AREAS OF UTILIZATION
• It can be used on roughcast on the interior facades of all buildings.
ADVANTAGES OF THE PRODUCT
• It provides fast preparation and easy application. • It has high resistance to cracking. • It has high water vapor permeability. • It produces surfaces that are not affected by moisture. • It has higher adherence and strength compared to plaster and plaster-based
mixtures.
• After the rough plaster application, it is mixed with Satin Paste and provides a
suitable surface for the final coat Satin Paste.
The application surface should be clean; the surface should be free from dust and
mold oil.
• If there are defects and deep cavities on the surface before application, they
should be repaired
• with the same product one day before
• If lath strip is to be applied to the wall, the laths must be fixed to the surface at
least 1 day before the application.
• If the surface is too hot or absorbent under the influence of the sun, it should be
wetted.
• WERIMIT WEPRIME-GROSS is applied on exposed concrete surfaces before the
application and the application is started after primer’s drying.
STANDARD NO
• TS EN 998-1 / LW – 06.02.2017
COLOR
• White
TECHNICAL SPECIFICATIONS
• Class of reaction to fire: A1
• Application Temperature : +5˚C / +35˚C
• Mixing Ratio:8,5-9,5 liters of water/30kg
• Potlife:1hour • Dry Bulk Density: ≤ 1300 kg/m3
• Bonding Strength: ≥ 0.05 N/mm² - FP : B
• Compressive Strength : CS III, 3.5 ≤ x ≤ 7.5 N/mm²
• Thermal conductivity: ≤ 0.45 W/ m.K (P=50% TS EN 1745)
• Water absorption: Wo
• Water vaporpermeability coefficient (μ):≤35
• ApplicationThickness:Maximum 6mm
• Smoothing Time: 10-15 min.
• Serviceable after: 2 days
• Full Drying Time: 14 days
• Time to Wait Between Coats: 3 hours
• Temperature Resistance After Application -20° C / + 80° C
• Consumption Amount: 13 kg/m²
(for thickness of 1 cm)
• The above data was obtained based on the results of laboratory tests, and values may
vary due to differences in the construction site environment.
APPLICATION
• 30 kg WERIMIT PLASMIT-SATIN (Satin Plaster) is poured into approximately 8.5-9.5 liters
of clean water and mixed with a mixer until no lumps remain.
• The mortar is rested for 5 minutes, and it is mixed again for 1-2 minutes so that the
mixture has a homogeneous form.
• Plaster mesh should be applied at the junction points of different materials.
• Application in strong wind should be avoided. Against fast drying, the application
surface should be saturated with water.
• WERIMIT PLASMIT-SATIN can be applied alone on roughcast or mixed with WERIMITPLASMIT PASTE.
• In order to obtain a smooth surface, it should be trowelled.
• Surface after application; it should be moistened at regular intervals for 2-5 days, taking
into account the weather conditions.
• At least 1 week should be waited for WERIMIT PLASMIT PASTE application on WERIMIT
• PLASMIT-SATIN.
• Shelf life is 9 months when stored in its unopened original package in a way that is not
exposed to moisture, dry and direct sunlight, provided that it is placed in a maximum of
8 rows on top of each other.