PRODUCT DESCRIPTION
•It is a cement-based, high-performance, smooth surface-forming Cement Plaster that can be applied indoors and outdoors. Bricks, Pumices, Briquettes etc. It can also be used in bricking and repair works.
AREAS OF UTILIZATION
•It is directly applied on brick, pumice, briquette, pre-spread aerated concrete surfaces on the interior and exterior facades of all buildings and also on concrete, exposed concrete, ceiling surfaces, on which WERIMIT WEPRIME-GROSS has been applied.
•It can also be used as Brick, Pumice and Briquette masonry mortar.
ADVANTAGES OF THE PRODUCT
•Easy and quick application.
•It provides good performance due to its high adherence property.
•It is used as a primer mortar on surfaces.
•It is used in pumice, briquette, bricklaying.
TECHNICAL SPECIFICATIONS
• Class of reaction to fire: A1
• Application Temperature: +5 ˚C / +35 ˚C
• Mixing Ratio: 6,5-7 lt. water/40 kg
• Pot Life: 30 hours
• Compressive Strength: CS II, 1,5 ≤ X ≤ 5 N/mm²
• Bonding Strength: ≥ 0,05 N/mm² - FP : B
• Water absorption: W0
• Water vapor permeability coefficient (μ) : ≤ 35
• Dry Bulk Density: 1500 kg/m³ ±400
• Thermal conductivity: (λ1 0;dry) ≤ 1 W/ mK (P=50% TS EN 1745)
• Temperature Resistance: -20°C/+80°C
• Processing Time: 20-30 min.
• Full Drying Time: 10 days
• Application Thickness: Maximum 5 cm (in double coating application)
• Consumption: 16 kg/m²
/mm
• The above data was obtained based on the results of laboratory tests, and values may
vary due to differences in the construction site environment.
APPLICATION
• 40 kg bag of WERIMIT WEPLAS-MORTAR is slowly poured into approximately 6.5-7 liters
of water and mixed with a mixer so that no lumps remain.
• The prepared mixture is rested for 5 minutes, and it is mixed again for 1-2 minutes so
that the mixture has a homogeneous form.
• Plaster mesh should be used at the junctions of different materials.
PLASTER APPLICATION
• The prepared mortar is applied to the surface with a trowel.
• For applications thicker than 2.5 cm, the second layer should be applied after 1-2 hours.
Total plaster thickness should not exceed 5 cm.
• In order to obtain a smooth surface, it should be surface finished.
• After the application, the surface should be watered at regular intervals for 3-5 days.
• In windy or very hot weather WERIMIT WEPLAS MORTAR should be protected against fast
drying.
• At least 1 week should pass for Finish Plaster application.
BRICKING APPLICATION
• Bricks, pumices, briquettes, etc. can be easily laid with WERIMIT WEPLAS-MORTAR
when mixed with water; it produces solid and durable surfaces. It does not leave gaps
between the bricks (brick, pumice, briquette) and fills them completely